ndoo.sg

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Graw DFM-17 Radiosonde ======

===== UART Bootloader & Programming =====

==== Prerequisites ====

  - Custom USB Mini-B Cable
  - [[https://www.st.com/en/development-tools/stm32cubeprog.html|STM32CubeProgrammer]]

=== Custom USB Mini-B Cable ===

^ USB Mini-B ^ Color Code (USB) ^ Signal ^
| +5V | Red | +5V |
| USBD- | White | TXD |
| USBD+ | Green | RXD |
| GND | Black | GND |

==== Steps ====

  - Prepare the custom cable (refer to section below)
  - Connect the custom cable to a USB-TTL serial UART adapter (do not power the adapter up yet)
  - Short these 2 pins (I used a pair of tweezers), this sets BOOT0 pin high\\ {{:projects:amateur_radio:radiosondes:dfm-17_boot0.png?200}}
  - Connect the USB-TTL serial UART adapter to your computer
  - Launch STM32CubeProgrammer
  - Select UART connection and the correct serial port for your USB-TTL adapter\\ {{:projects:amateur_radio:radiosondes:stm32cubeprogrammer_uart.png?200}}
    - If this is your first time programming the DFM-17, Read Unprotect (MCU) must also be checked (:!: factory firmware will be erased :!:)\\ {{:projects:amateur_radio:radiosondes:stm32cubeprogrammer_unprotect.png?200}}
  - Click Connect
  - If connection succeeds, you can disconnect the shorted BOOT0 pins
  - You can now program the DFM-17 as you like (Read Unprotect (MCU) does not need to be checked for future re-connection attempts)

{{:projects:amateur_radio:radiosondes:img_3063.png?400}}

===== SWD Programming =====

:!: Requires soldering to PCB

Refer to [[https://wiki.recessim.com/view/DFM-17_Radiosonde#SWD_Header|DFM-17 Radiosonde - SWD Header]]

===== Others =====

==== Useful CLI Commands ====

  * Initial unlock (disable Readout Protection)
    * STM32CubeProg: ''%%STM32_Programmer_CLI -c port=YOUR_COM_PORT_OR_TTY br=115200 -rdu%%''
    * [[https://sourceforge.net/p/stm32flash/wiki/Home/|stm32flash]]: ''%%stm32flash -k YOUR_COM_PORT_OR_TTY%%''
    * [[https://openocd.org/|OpenOCD]]: ''%%openocd -f interface/stlink.cfg -f target/stm32f1x.cfg -c "init" -c "reset init" -c "stm32f1x unlock 0" -c "reset halt" -c "exit"%%''
ndoo.sg

User Tools

Site Tools

Page Tools
